3-Bolt TR6060 Output Flange Adapter

The hole in the center is to small to fit the little shaft that sticks out of the flange on the transmission I will have to get the hole drilled out larger. Looks like to me that the hole is .625 and it needs to be .630

The center hole on the adapter was not big enough to fit the tr6060 so I hade to make it a little larger but otherwise it’s great and I’m glad I don’t have to tear the yoke out of the transmission

AWESOME PRODUCT, VERY HIGH QUALITY AND VERY FAST SHIPPING, HIGHLY RECOMMEND!

The FABbot Tr6060 Output Flange Adapter is very well made. My one complaint about the adapter is the hole in the middle was too small to mount on the flange of the TR6060 out of the box. This was disappointing because the largest drill bit I had available was 1/2", which is smaller than the hole to start. I had to first locate a larger bit and used my drill press to enlarge the hole symmetrically to maintain the balance of the adapter. Long story short, the adapter is mounted to the flange. An accurate measurement for the manufacture of a drive shaft was made and I should have it in a couple of days.

The matarial and machining looks good but the center hole drilled for the output shaft didn't fit. I measured the hole and shaft with calipers and they were the same size so the adapter wouldn't fit around the shaft I could've forced it on with a rubber hammer and would've definitely gauled the aluminum of the adapter and shaft but decided to drill it out a 16th of an inch so it would fit without forcing it on. I emailed fabbot addressing the fitment issue but never got a reply. Trans is a GM tr6060 from a 5th gen Camaro