3-Bolt TR6060 Output Flange Adapter

The order came within a remarkable shipping time. I was accidentally shipped a 1350 u-joint as I requested a 1310. Within 24 hours I had a response from their customer service team. They shipped me the 1310 U-joint and also provided me with the return label to return the old one. FOR ALL THE PEOPLE COMPLAINING OF THE PILOT HOLE DIAMETER, It fits perfectly! You MUST clean the nipple of the 3-bolt flange with sand paper and degreaser before installation. If you do not do this it will not fit. Food for thought, dont be like these other morons. This is a 5-star product. Would buy again.

The hole in the center is to small to fit the little shaft that sticks out of the flange on the transmission I will have to get the hole drilled out larger. Looks like to me that the hole is .625 and it needs to be .630

The center hole on the adapter was not big enough to fit the tr6060 so I hade to make it a little larger but otherwise it’s great and I’m glad I don’t have to tear the yoke out of the transmission

AWESOME PRODUCT, VERY HIGH QUALITY AND VERY FAST SHIPPING, HIGHLY RECOMMEND!

The FABbot Tr6060 Output Flange Adapter is very well made. My one complaint about the adapter is the hole in the middle was too small to mount on the flange of the TR6060 out of the box. This was disappointing because the largest drill bit I had available was 1/2", which is smaller than the hole to start. I had to first locate a larger bit and used my drill press to enlarge the hole symmetrically to maintain the balance of the adapter. Long story short, the adapter is mounted to the flange. An accurate measurement for the manufacture of a drive shaft was made and I should have it in a couple of days.